So I got a good scare this morning after seeing this message. One of my WD backup drives (2 years old) went wonky. After playing around with the Sata connection, it fired up again. I ran a few health checks on Windows and Linux, everything checked out fine. So far, so good following several boots between the two.
What's the game plan for something like this?
Mechanical hard drive error
- TigerRaptor
- DBB Fleet Admiral
- Posts: 2678
- Joined: Tue Feb 01, 2000 6:00 am
- Krom
- DBB Database Master
- Posts: 16125
- Joined: Sun Nov 29, 1998 3:01 am
- Location: Camping the energy center. BTW, did you know you can have up to 100 characters in this location box?
- Contact:
Re: Mechanical hard drive error
https://crystalmark.info/en/download/#CrystalDiskInfo
Download crystal disk info and check over the S.M.A.R.T. status on the drive, post a screen shot if necessary. The status indicator on crystal disk info will generally reveal if the drive firmware has detected any potential issues. But basically anything but "Good" means you should discontinue use of the drive ASAP, get the data off of it, and then take it to the next free tech recycling day so it can be melted down and turned into a car part or something.
I keep crystal disk info running in the background and monitoring my drive health for all my drives. (Only polling once a day or in 1440 minute intervals, because there is no need to check them more frequently than that and polling SMART requires the drives to spin up out of idle.)
Download crystal disk info and check over the S.M.A.R.T. status on the drive, post a screen shot if necessary. The status indicator on crystal disk info will generally reveal if the drive firmware has detected any potential issues. But basically anything but "Good" means you should discontinue use of the drive ASAP, get the data off of it, and then take it to the next free tech recycling day so it can be melted down and turned into a car part or something.
I keep crystal disk info running in the background and monitoring my drive health for all my drives. (Only polling once a day or in 1440 minute intervals, because there is no need to check them more frequently than that and polling SMART requires the drives to spin up out of idle.)
- TigerRaptor
- DBB Fleet Admiral
- Posts: 2678
- Joined: Tue Feb 01, 2000 6:00 am
-
- Defender of the Night
- Posts: 13477
- Joined: Thu Nov 05, 1998 12:01 pm
- Location: Olathe, KS
- Contact:
Re: Mechanical hard drive error
Honestly, I would backup whatever data you have on that drive ASAP.
"One spelling mistake can destroy your life. A Husband sent this to his wife : "I'm having a wonderful time. Wish you were her." - @RobinWilliams
- TigerRaptor
- DBB Fleet Admiral
- Posts: 2678
- Joined: Tue Feb 01, 2000 6:00 am
Re: Mechanical hard drive error
Did that before posting this thread. So far the hard drive hasn't any issues. I'll give it another week and continue to monitor it with crystal.